Table of Contents
Advertisement
INSTALLATION
Step 1 Take out the M4856-P(indoor) from the carton; confirm whether the
accessories are complete，as shown in Figure 2.18
Figure 2.19 Remove the Decoration of M4856-P
Step 2 Pull down the buckles on the top and bottom of the battery and take out the
decoration, as shown in Figure 2.19
Figure 2.20 Remove the Wall Bracket of M4856-P
Step 3 Use T20 screwdriver to remove the 4 screws fixing the box and the wall
bracket, as shown in Figure 2.20
Figure 2.21 Install M4856-P Expansion Bracket
Step 4 Use SW7 sleeve or other tools for the M4 flange and M4 flange nuts to
connect the M4856-P wall bracket to the expansion bracket, as shown in Figure 2.21.
NOTE:
The connection points between the wall bracket and the expansion bracket must
be the two holes above (the holes for B3 expansion).
15
16
Step 5 After installing the expansion bracket, match the wall bracket with SMILE-B3, and
use M5*10 screws to lock and fix, then locate and trace.
NOTE:
If the positioner is not removed, SMILE-B3 can not be removed separately in the
future.
Step 6 Drill holes at the position using a percussion drill (M12 drill, depth of holes:
70mm). After drilling, put 4 expansion bolts into the hole and take out the expansion
screws as shown in Figure 2.23
Figure 2.22 Install the Positioning Bracket
Figure 2.23 Holes for Fixing Bracket
INSTALLATION
Advertisement
Table of Contents
