Item Selection - NF DP420LS Instruction Manual

3. Basic Operation

3.3.2 Item Selection

You can move the cursor (highlighted icon) by using arrow keys or the jog. However, some items
cannot be selected depending on your system. These items are skipped when moving the cursor. If
you press the ENTER key, the item under the cursor is selected and run. If the item is a menu, the
menu screen, window, or selection box is displayed. If you press the CANCEL key, the menu in the
upper hierarchy is displayed without selection or execution of that item.
 Selection box
If the menu has numbers before its menu items as shown in the screen below (selection box),
pressing the corresponding number on the numeric keypad also selects and runs the item. You can
also move the cursor by using the shuttle.
If you select an item with
displayed. In addition to the ENTER key, you can also use  arrow key to open the selection box of
that menu.
You cannot select grayed items in a selection box, which are different depending on setting.
  Data list box
When selecting data in the memory, the data list box shown in the screen below is displayed. To
select a data in a data list box, hover the cursor over the box by using the arrow keys or jog and press
the ENTER key. This operation enables the cursor to move over each data in the data list box. Hover
the cursor over the item you want to select by pressing the up or down arrow key or turning the jog or
shuttle and press the ENTER key.
30
on the right, the selection box in the lower hierarchy menu is
PROGRAMMABLE AC POWER SOURCE