Sequence - NF DP420LS Instruction Manual

11. Specifications

11.18 Sequence

Effective only for AC-INT, AC+DC-INT, and DC-INT.
Number of memories
Number of steps
Setting range of Step Time
Intra-Step behavior
Parameter
Sequence control
*43: For DC-INT, the AC voltage, frequency, waveform, Start Phase, and Stop Phase cannot be set.
*44: The Start Phase and Stop Phase are specified for the L1 phase, and the component of the Phase
angle setting is added to them for the other phases.
250
5 (non-volatile)
Maximum 255 (for each sequence)
0.0010 s to 999.9999 s
Constant, Keep, Linear Sweep
Output range
*43 *44 AC/DC mode (The signal source
is fixed to INT)
(The above 2 items are common
within one sequence)
AC voltage, frequency, waveform
DC voltage
Start Phase
Stop Phase
Step termination
Jump count (1 to 9999, or infinite)
Specification of the Jump-to step
Synchronous step output (2-bit)
Specification of the branch step
Trigger output
Start
Stop
Hold
Resume
Branch 1, Branch 2
Single
Output range
AC/DC mode (The signal source
is fixed to INT)
(The above 2 items are common
within one sequence)
AC voltage, frequency, waveform
Start Phase
Stop Phase
Phase angle
Step termination
Jump count (1 to 9999, or infinite)
Specification of the Jump-to step
Synchronous step output (2-bit)
Specification of the branch step
Trigger output
PROGRAMMABLE AC POWER SOURCE
Polyphase system