3. Basic Operation
2. In the [Target Phs] item, select the phase of which the measured value is to be displayed. For
the line voltage, select L1-L2, L2-L3, or L3-L1.
3. Close the window. For how to close the window, see 3.3.4.
Operation procedures by using shortcuts
1.
+
Press the SHIFT key to enter the shift state (the SHIFT LED illuminates). When you press the 2
key in the numeric keypad in the shift state, the phase is switched in the order of
L1 L2 L1-L2 L1 ... in the single-phase three-wire. In the three-phase, it is switched in the
order of L1 L2 L3 L1-L2 L2-L3 L3-L1 L1 ...
54
Switches the target phase of which the measured value is displayed
PROGRAMMABLE AC POWER SOURCE