Rs232 - NF DP420LS Instruction Manual

6. Remote Control
5. Use a commercially available USB cable (Type A to B) to connect this product to the computer.
USB connector is available on the rear of this product.
-------- Notes ------------------------------------------------------------------------------------------------------------
 Avoid use in a place under electrically noisy environment.
 It is recommended to use a fully-shielded, short cable.
 The use of USB hub may cause the product not to communicate properly.
-----------------------------------------------------------------------------------------------------------------------------
 About USB ID
Used for a system connected with multiple DP series programmable AC power sources through USB,
to enable the application identify each source. The USB ID is represented in the following format.
USB0::[Vendor number]::[Product number]::[Serial number]::INSTR
Vendor number:
Product number:
Serial number:

6.1.2 RS232

For the interface specifications, see 11.27.
 Operation procedure
1. Press the MENU key to move to the root menu, then select [System]. The system setting
window opens.
200
Fixed to 3402 (0x0D4A)
Fixed to 26 (0x001A)
A unique number (serial number) has been set for each product.
PROGRAMMABLE AC POWER SOURCE