NF DP420LS Instruction Manual page 204

Setting Item
LCD display
Beep
Key lock
Output relay control
Output setting at power-on
Trigger output setting
Time unit
Monitor output target
External interface
External control
Clipped sine wave
Arbitrary Waveform Memory
Sequence parameters
Simulation parameters
DP420LS/DP480LS
Table 4-17 Setting Items to be Reset (Continued)
Reset
×







×
×

×
×
×
4.27 Restoring to the Factory Default Setting (Reset)
Factory default setting
Blue tone
On
Off
Enable
Off
Negative, 10 ms
s
Current (L1 phase)
USB
Disable
Clip ratio specified
Clip ratio: 100 %
Crest factor: 1.41
ARB1 to 8: Triangle wave
ARB9 to 16: Square wave
Output range: 100 V
AC/DC mode: AC-INT
Step Time: 0.1000 second
Intra-Step behavior: Constant
Waveform: SIN Frequency: 50 Hz
DC voltage: 0 V AC phase voltage: 0 V
Start phase: Disabled, 0 deg
Stop phase: Disabled, 0 deg
Phase angle: Single-phase three-wire 180 deg
Three-phase 120, 240 deg
Step termination: Continue
Jump count: 1
Jump-to step specification: OFF
Step sync output: LL
Branch step specification: OFF
Trigger output: Off
Output range: 100 V
Step Time: 0.1 second
Frequency: 50 Hz AC voltage: 0 V
Start phase: Disabled, 0 deg
Stop phase: Disabled, 0 deg
Step sync output: LL
Trigger output: Off
Repeat count: Disabled 1
185