ADTRAN Total Access 3000 System Manual page 427

Perform Steps Below in the Order Listed
10. Place Equipment In Service
1.) Access the menus for the Intelligent NE (Host) shelf by either connecting
through the front panel craft port (see DLP-715) or by Telnet session if
connected to the LAN.
2.) From the Main Menu, select OC-3 MUX.
3.) From the OC-3 MUX Main Menu, select Provisioning.
4.) From the Provisioning Menu, select MUX Provisioning.
5.) From the MUX Provisioning Menu, set MUX Service State to In Service.
6.) Press <Esc> to return to the Provisioning Menu and select EC-1 #1
Provisioning.
7.) From the EC-1 #1 Provisioning Menu, set Service State to In Service.
8.) Press <Esc> to return to the Provisioning Menu and select EC-1 #2
Provisioning.
9.) From the EC-1 #2 Provisioning Menu, set Service State to In Service.
In redundant applications, the Service States for both A and B OC-3 L2 MUX
must be placed In Service individually.
10.) Exit the menus for the Intelligent NE (Host) shelf and access the menus for
the Expansion Shelf (Client) by either connecting through the front panel
craft port (see DLP-715) or by Telnet session if connected to the LAN.
11.) From the Main Menu, select STS-1 MUX.
12.) From the STS-1 Main Menu, select Provisioning.
13.) From the STS-1 Provisioning Main Menu, set Service State to In Service.
14.) Press <Esc> to return to the Total Access Main Menu.
In redundant applications, the Service State for both A and B STS-1 L2 MUX
must be placed In Service individually.
15.) Repeat steps 10-14; section 1.2.10 above for each of the Expansion Shelves.
Total Access ® 3000/3010 System Manual
TOTAL ACCESS 3000/3010
NOTE
NOTE
6TADLP744-1E
DLP-744
Page 9 of 12
© 2003, ADTRAN, Inc.