ADTRAN Total Access 3000 System Manual page 393

1.1 Provisioning the STS-1 Multiplexer Module
References to common, but differing, parameters between the Total Access
3000 and the Total Access 3010, such as number of slots, will be conveyed
by the convention a/b. The "a" represents the Total Access 3000 parameter
and the "b" represents the Total Access 3010 parameter. For example, the
differing number of access slots in the two platforms, 28 for the Total Access
3000 and 22 for the Total Access 3010, would be displayed "28/22."
1.1.1 Introduction
This section provides step-by-step instructions for the provisioning of a Total Access
3000/3010 STS-1 MUX module. In the case of 1:1 protection, instructions are
included for the provisioning of the working and protect modules.
1.1.2 Prerequisite Procedures
The following procedures must be completed prior to provisioning the STS-1 MUX
module and are assumed to have been completed. If necessary, refer to the appropriate
documentation before proceeding. The prerequisite procedures include:
• Installation and wiring of Total Access 3000/3010 shelf and SCU – NTP-501
• BNC module installation – DLP-708
• Coaxial cable installation – PREP-401, DLP-709
• Physical installation of STS-1 MUX Module – NTP-505
1.1.3 Tools Required
A pen or pencil will be required to operate the recessed APS button on the faceplate of
the unit.
1.1.4 Materials Required
• Total Access 3000/3010 STS-1 MUX module (2 modules for 1:1 protection
switching applications)
Total Access ® 3000/3010 System Manual
TOTAL ACCESS 3000/3010
NOTE
6TADLP741-1E
DLP-741
Page 1 of 8
© 2003, ADTRAN, Inc.