ADTRAN Total Access 3000 System Manual page 317

1.1 Logging On to the System
Perform Steps Below in the Order Listed
References to common, but differing, parameters between the Total Access
3000 and the Total Access 3010, such as number of slots, will be conveyed
by the convention a/b. The "a" represents the Total Access 3000 parameter
and the "b" represents the Total Access 3010 parameter. For example, the
differing number of access slots in the two platforms, 28 for the Total Access
3000 and 22 for the Total Access 3010, would be displayed "28/22."
1.1.1 Introduction
Once connected to the Total Access 3000/3010 SCU via either a VT100 terminal or
PC configured as a VT100 terminal, it is necessary to logon to the system to gain
access to the management and provisioning functions. This section of the Installation
and Turn-up Procedure details the specific procedure for logging on to the system, and
accessing the various management and provisioning functions.
1.1.2 Prerequisite Procedures
DLP-715, Connecting the Terminal or PC to the Craft Port, needs to be completed
before logging on to Total Access 3000/3010.
1.1.3 Tools and Materials Required
• Data cable to connect to VT100 terminal or PC configured as a VT100 terminal
• VT100 or PC configured as a VT100 terminal
1.2 Detailed Level Procedure 716
1.2.1 To log in to the Total Access 3000/3010 menu structure
1. After connecting to the system as described in DLP-715, a blank screen will
appear.
Pressing any key will bring up the logon screen. Upon entering the logon screen,
the cursor will blink at the Account Name field.
2. At the Account Name field, input the Account Name, and press <Enter>.
The cursor will blink at the Password field.
Total Access ® 3000/3010 System Manual
TOTAL ACCESS 3000/3010
NOTE
6TADLP716-1E
DLP-716
Page 1 of 4
© 2002, ADTRAN, Inc.