ADTRAN Total Access 3000 System Manual page 247

1.1 Acceptance Test Procedure for
Total Access 3000/3010 Shelf, CO Installation
References to common, but differing, parameters between the Total Access
3000 and the Total Access 3010, such as number of slots, will be conveyed
by the convention a/b. The "a" represents the Total Access 3000 parameter
and the "b" represents the Total Access 3010 parameter. For example, the
differing number of access slots in the two platforms, 28 for the Total Access
3000 and 22 for the Total Access 3010, would be displayed "28/22."
1.1.1 Introduction
This procedure details the test steps which must be performed to verify that one or
more Total Access 3000/3010 shelves have been properly installed in a central office
(CO). An Acceptance Test Checklist is provided at the end of this procedure for
sign-off on completion of this phase of installation.
1.1.2 Prerequisite Procedures
Before beginning this procedure, you should have completed all of the installation
tasks detailed in NTP-501.
1.1.3 Tools and Materials Required
• Total Access 3000/3010 Test Access Module (TAM) Card, P/N 1181980L1
• Oscilloscope (optional)
• A remote terminal computer system with a modem (if Total Access 3000/3010 is
connected to an external modem)
• Access to a computer with LAN access (if the Total Access 3000/3010 is connected
to a LAN)
To prevent electrical shock, do not install equipment in a wet location or
during a lightning storm.
Electronic modules can be damaged by static electrical discharge. Before
handling modules, wear an antistatic discharge wrist strap to prevent damage
to electronic components. Place modules in antistatic packing material when
transporting or storing. When working on modules, always place them on an
approved antistatic mat that is electrically grounded.
Total Access ® 3000/3010 System Manual
TOTAL ACCESS 3000/3010
NOTE
WARNING
CAUTION
6TAATP601-1E
ATP-601
Page 1 of 4
© 2002, ADTRAN, Inc.