ADTRAN Total Access 3000 System Manual page 223

1.5 Connect Terminal or PC to Craft Port
Connect either a VT100 terminal or a PC emulating a VT100 terminal to the craft
interface on the SCU faceplate.
1.6 Provision the Replacement SCU
It will be necessary to provision the new SCU since it is unable to Auto-Provision
itself. Provisioning can be done through the craft interface or from the faceplate of the
unit using the Four-Character Display (FCD) and faceplate toggle switch.
To provision the SCU via the craft interface, perform the following:
1. Logon to the system
2. Configure Target ID (TID) and Number
3. From the Total Access Menu, select option 1, System Controller, and press
<Enter>.
4. From the System Controller Menu, select option 2, Provisioning, and press
<Enter>.
5. From the Provisioning Menu, select option 1, General, and press <Enter>.
6. From the General Menu, select option 1, Management Ports, and press
<Enter>.
7. From the Management Ports Menu, select option 5, Interbank Comm. Mode,
and press <Enter>.
8. From the Interbank Comm. Mode Menu, select either option 1, Host, for Host
Mode, or option 2, Client, for Client Mode, and press <Enter>.
9. Return to the Provisioning Menu by pressing <Esc>.
From the Provisioning Menu, configure the replacement SCU with the remaining
provisioning items that were written down at the beginning of this procedure.
1.6.2 Provision IP Network Settings
If the Total Access 3000/3010 is to be connected to an IP network for Telnet, TFTP or
SNMP management, there are several IP parameters that need to be set for the shelf to
communicate with the network. These settings are included in those written down
prior to the replacement.
Total Access ® 3000/3010 System Manual
NOTE
The default band rate for new units is 9600.
6TANTP507-1E
TOTAL ACCESS 3000/3010
For details, go to: DLP-715.
For details, go to: DLP-716.
For details, go to: DLP-717.
For details, go to: DLP-718.
© 2002, ADTRAN, Inc.
NTP-507
Page 5 of 6