ADTRAN Total Access 3000 System Manual page 392

6TADLP740-1E
TOTAL ACCESS 3000/3010
DLP-740
Page 10 of 10
Perform Steps Below in the Order Listed
Assigning the incorrect embedded DSX-1 from the DS-3 to a slot in the Total
Access 3000/3010 could disrupt existing traffic.
3. Return to the Primary MUX Main menu by pressing <Esc>.
This concludes the procedure for provisioning a single MUX in a non-protection
configuration or the Primary MUX in a protection configuration. Please proceed to
Section 1.7 for provisioning the Protect MUX in a protection configuration.
1.7 Preparing to Provision the Protect MUX (slot B)
Ensure that Linked Provisioning is "Enabled" on the Working MUX before
proceeding. The factory default setting for Linked-Provisioning is 'Enabled' and
should be already set. The procedure to access this feature is listed below for
convenience.
1. From the Total Access Main menu, select option 2, Common A, and press <Enter>.
This will be the menu tree for the DS-3 MUX in slot A.
2. From the DS-3 MUX A Menu, select option 2, Provisioning, and press <Enter>.
Check to see if Enabled or Disabled. To enable, continue with the next two steps.
3. From the Provisioning Menu, select option 5, Linked Provisioning, and press
<Enter>.
4. From the Linked Provisioning menu, select option 2, Enable, and press <Enter>.
5. Return to the Total Access Main Menu by pressing <Esc> key.
The Protect MUX in slot B should now be provisioned with the identical settings as
the Primary MUX in slot A.
1.8 Follow-up Procedure
This completes the procedure for provisioning the Total Access 3000/3010 DS-3
Multiplexer Module. Proceed to Section 1.5, Placing the Units in Service, of NTP-504.
If this procedure was called out from another document, return to that document and
continue.
© 2003, ADTRAN, Inc.
CAUTION
Total Access ® 3000/3010 System Manual