ADTRAN Total Access 3000 System Manual page 423

Perform Steps Below in the Order Listed
6. Provision SCU in the Intelligent NE (Host) Shelf
1.) Access the menus for the Intelligent NE (Host) shelf by either connecting
through the front panel craft port (see DLP-715) or by Telnet session if
connected to the LAN.
2.) From the Main Menu, select System Controller.
3.) From the System Controller Main Menu, select Provisioning.
4.) From the Provisioning Menu, select General.
5.) From the General Menu, select Management Ports.
6.) From the Management Ports Menu, select Interbank Comm. Mode.
7.) Set Interbank Comm. Mode to Host.
8.) Verify that the HST LED on the SCU front panel is green.
9.) Press <Esc> until you have returned to the SCU Provisioning Menu.
10.) Select TL1.
11.) From the TL1 Menu, select Target ID (TID) and enter the valid Target ID
that was obtained from the Network Administrator.
12.) Select Legacy AID Compatibility and set to Enable.
The Legacy AID Provisioning option is set to Enabled so that the OC-3 L2
MUX may be supported by previous NMA templates that do not support
subtended STS-1 circuits. This option should only be enabled when using the
OC-3 L2 MUX (P/N 1181031L2) and compatible NMA templates.
13.) Press <Esc> to return to the Total Access Main Menu.
Total Access ® 3000/3010 System Manual
TOTAL ACCESS 3000/3010
NOTE
6TADLP744-1E
DLP-744
Page 5 of 12
© 2003, ADTRAN, Inc.