Chapter 4
Machine's Boom Function Coils
FIGURE 10.
Use a test light or multi-meter to locate the machine's Left and Right Up/Down coils.
11.
Remove the nuts from the coils.
12.
Connect the 2010 Spray-Air boom sense adapter cable (P/N 115-0230-001) ring cables to the appropriate
13.
boom function coils.
Replace the nuts on the coils.
14.
On the harness cable, locate the Left Solenoid Sense connectors. Isolate the connector labeled Up and
15.
connect it to the Left Tilt Up coil via the installed boom sense adapter cable.
Connect the Down Left Solenoid Sense connector to the Left Tilt Down coil via the installed boom sense
16.
adapter cable.
Connect the Right Solenoid Sense connectors to the machine's Right Tilt Up and Right Tilt Down coils via
17.
the installed boom sense adapter cables.
Install the Center Rack Control
Machine's Center Boom Function Coils
FIGURE 11.
Locate the Center Up coil on the machine's center section control valve, located beneath the machine's
1.
hydraulic valve on the center rack.
Unplug the coil connector from the Center Up coil.
2.
Install a center rack control boom sense adapter cable (P/N 115-0230-037) to the machine's Up coil.
3.
40
Miller Condor Spray-Air Boom AutoBoom Installation Manual