Table of Contents
Advertisement
C
5
HAPTER
19. Install a boom sense adapter cable (P/N 115-0171-546) on the open center coil.
20. Connect the machine's harness cable to the installed boom sense adapter cable.
21. Connect the Open Center Valve connection on the AutoBoom harness cable to the single weatherpack
connection of the installed boom sense adapter cable.
NOTE:
The system will now disengage when Up is pressed on the machine's controller. The system must be
engaged via the AutoBoom controller or field computer screen.
INSTALL THE CENTER RACK CONTROL
FIGURE 15. Machine's Directional Coil
1. Locate the machine's directional coil.
2. Disconnect the machine's directional coil connector from the directional coil.
3. Install the center rack control boom sense adapter cable on the machine's directional coil connector.
• Black directional coil with permanent lead wire attached to the coil, install cable P/N 115-0230-081.
• Silver directional coil with built-in Deutsch connector, install cable P/N 115-0230-039.
4. Connect the Center Solenoid Down Sense connections on the AutoBoom harness (P/N 115-0230-045 or 115-
0230-085) cable to the Open single weatherpack connections on the center rack control boom sense adapter
cable (P/N 115-0230-081 or 115-0230-039).
FIGURE 16. Center Rack Control Coil
60
Fast 9600 - 80'-120' Booms AutoBoom Installation Manual
Advertisement
Table of Contents
