Table of Contents
Advertisement
C
7
HAPTER
FIGURE 13. Power Stud Location
Power Stud Location
9. Connect the ignition power ring terminal to the power stud located towards the right-hand side of the machine
from the constant power stud.
CENTER RACK CABLE HARNESS INSTALLATION
1. Locate the provided center rack cable harness (P/N 115-7303-327).
2. Locate the breakout with the 12-pin Deutsch receptacle and the large-round connector.
3. Install these connectors into the bulkhead bracket near the right hand linkage of the center rack.
34
Hagie Hawkeye® Installation Manual
Advertisement
Table of Contents
