Chapter 4
Mount the Center Rack Sensor
Center Sensor Mounted to the Machine
FIGURE 6.
Mount the center sensor (P/N 063-0130-018) to the machine's center rack boom tube using two 1-1/2" W x
1.
2-1/2" L x 3/8" thread U-bolts (P/N 435-3003-047).
Tighten the nuts to ensure the sensor is mounted securely.
2.
Connect the Sensor Cables
Connect the left sensor cable (P/N 115-0171-527) to the connector on the left sensor.
1.
Route the left sensor cable toward the AutoBoom valve.
2.
Loop and tie-off any excess cable, allowing enough cable for boom folding and extension.
3.
Repeat the steps above to connect the remaining sensor cables.
4.
Note:
The sensor cables will be connected to the AutoBoom system in the wiring phase of installation.
36
Miller Condor Spray-Air Boom AutoBoom Installation Manual