Table of Contents
Advertisement
Figure 34. Filler installation
Step 5.
Reinstall the cover (see "Installing the compute node cover" on page 107).
Step 6.
Slide the compute node into the rack.
Step 7.
Reconnect the power cords and any cables that you removed.
Step 8.
Turn on the peripheral devices and the compute node.
Removing the front handle
Use this information to remove the front handle.
Before you remove the front handle, complete the following steps:
1. Read "Safety" on page v and "Installation guidelines" on page 89.
2. If the compute node is installed in an IBM NeXtScale n1200 Enclosure, remove it (see "Removing a
compute node from a chassis" on page 92 for instructions).
3. Carefully lay the compute node on a flat, static-protective surface with the cover side down, orienting
the compute node with the bezel pointing toward you.
To remove the front handle, complete the following steps.
Filler
.
Chapter 5
Removing and replacing components
115
Advertisement
Table of Contents
Troubleshooting
