Gyro-Sense (Car & Boat); Speed (Car & Boat) - RadioLink AT9S Pro Instruction Manual

is risk of crash for airplanes. Set MIX to INH or On. SWA to SWH can be set as switch to control the function.
There are two modes, including RATE and THROTTLE.
RATE: When turning on the switch, the throttle will keep at a certain rate to run. The range is from 0% to 100%,
the lowest to the highest.
THROTTLE: Assign a switch to turn on/off the function, when it is on, the throttle will run with the speed
corresponding to the position at that time.
Goals
Set up throttle hold.
Determine desired throttle
position by idling engine, turn
on THR-HOLD , and adjust
percentage as required to reach
the desired running point.
3.4.6 GYRO-SENSE (Car & Boat)
This function is to set gyro sensitivity for car and boat.
When MIX set OFF, gyro is disabled while when MIX set ON, you can adjust gyro sensitivity. The channel can
be set from channel 5 to channel 10. After setting the channel of GYRO, connect the channel with receiver.
The range of sensitivity is 0%-100%.
Goals
Set up Gyro Sensitivity
3.4.7 SPEED (Car & Boat)
The function is to set THSPD, ACCEL and IDLUP, which can effectively avoid skid and reduce the harm to the
models.
The range of THSPD is from 0% to 100%, and it defaults to 100%. THSPD can start the car more smoothly
and reduce the consumption of the battery. When the car is running at smooth road, sudden acceleration
may cause skid. The range of ACCEL is from 0% to 100%, and it defaults to 100%. The rate is set to control
the brake action. The range of IDLUP is from 0% to 100%, and it defaults to 0%. The higher the rate is, the
Steps
Open THR-HOLD
function.
again)
Activate the function.
Set desired engine
position.
Close
Steps
Open
Gyro Sensitivity
function.
again)
Activate the function.
Set desired channel
and rate .
channel and rate
Close
78
深圳市乐迪电子有限公司
www.radiolink.com
Inputs
for 1s to BASIC.(If ADVANCE
to THR-HOLD
to MIX to OFF
，
to POSI to desired percent
，
Inputs
for 1s to BASIC.(If ADVANCE
to
Gyro Sensitivity
to MIX to ON
，
to channel and rate， to desired