3.3.3 GYRO SENSE
About GYRO SENSE, there are two types: STD and GY. please refer to
3.3.12, by following steps:
Goals
Open and activate the GYRO
SENSE function.
Activate the function.
Set up heading-
hold /AVCS gyro
Optional: Change gyro types to
with
Heading- hold ( GY ).
heading-hold/AVC
S setting in
idle-ups
1 and 2
Adjust gyro rates as needed.
and normal mode
(Ex: NORM , IDL3 to NOR 50% .
setting in idle- up3
IDL1 and 2 to AVC 50% as
and normal.
starting points.)
Close
3.3.4 REVO MIX
This 5-point curve mix adds opposite rudder input to counteract the changes in torque when the speed and
collective pitch of the blades is changed.
Adjustability:
• Three separate curves available: normal for hovering; idle-ups 1 and 2 combined; and idle-3.
• Normal condition curves are editable in the BASIC menu for convenience.
• All curves may be adjusted in the ADVANCE menu.
• Correct mix is automatically selected in-flight with each condition and automatically activated when the
throttle setup for that condition is activated in the programming (i.e. THROTTLE HOLD or THR-CURVE.)
• To change which condition's curve is being edited, cursor up above POINT5 and select. For clarity, the name
of the condition currently active (switched on at the radio) is shown in parentheses behind the name of the
condition whose curve is being edited.
Revo. Mixing rates are 5-point curves. For a clockwise-turning rotor, the rudder is mixed in the clockwise
direction when collective pitch is increased; for counterclockwise-turning, the opposite. Change the operating
Steps
Optional: Changes switch
Ex: select Cond .
assignment.
Inputs
for 1s to BASIC.(If ADVANCE
again) .
to GYRO-SENSE
to MIX
,
to MODE
,
to SW
,
to NORM,
,
to IDL1
,
Repeat.
67
深圳市乐迪电子有限公司
www.radiolink.com
to ACT.
to GY
to Cond
to NOR 50%
to AVC 50%