Flaperon (Acro/Glid 1A+1F ) - RadioLink AT9S Pro Instruction Manual

• HELI Defaults:
• PROG.MIX5 aileron-to-elevator for coordinated turns
• PROG.MIX6 aileron-to-elevator for coordinated turns
• Master: The controlling channel can only be a channel. Cannot OFFSET or dial.
• Trim: not available in curve mixes.
• Offset: not available in curve mixes.
Goals
Set up a RUDD-ELEV curve
mix on a model that pitches
down severely at full rudder
and not at all with minimal
rudder input, and pitches
worse on right rudder than
left:
Point 1: 25%
Point 2: 8%
Point 3: 0%
Point 4: 10%
Point 5: 28%
ON when SWITCHC is down.
LINK should be ON if model
has twin el e v a t o r s e r v o s .
O t h e r w i s e , LIN K remains
OFF .
(Note that point 3 is 0%.
Otherwise, the elevator would
be retrimmed when the mix is
active and no rudder input is
given.)

3.1.2 FLAPERON (ACRO/GLID 1A+1F )

The FLAPERON mixing function uses one servo on each of the two ailerons, and uses them for both aileron
and flap function. For flap effect, the ailerons raise/lower simultaneously. Of course, aileron function (moving
in opposite directions) is also performed.
Note: When changing the polarity of a rate, "change rate dir?" is displayed for a check. Please set up after
pressing DIAL for 1 second and canceling an alarm display. (GLID only)
Steps
Open an unused
programmable mix.(Ex: use
PROG.MIX7 since it is already
set up for FLAP-ELEVATOR)
Activate the function
Choose master and slave
channels.
Set LINK as needed( Ex: off)
Assign SWITCH and position.
(Ex: change from F to C ，
Down)
Optional: set switch to
STK-THR to activate mix with
THROTTLE STICK.
Optional: set switch position to
NULL. Make mix active at all
time. Not complete with
STK-THR.
Set desired percent at five
stick points.
Close
43
Inputs
to BASIC menu,
ADVANCE
to PROG.MIX PUSH
to MIX，PUSH，
Already RUDD. Already ELEV
to SW.PUSH. to C,PUSH
to POSI, PUSH.
to POSI， Throttle Stick to desired
point .
Push 1sec.to set.
to POSI, PUSH,
to POINT -1 to 25% ，
Repeat for points 2-5.
again to
7，PUSH
to ON, PUSH
to DOWN
to NULL