Binding; Installment Of Antenna - RadioLink AT9S Pro Instruction Manual

1.3.4 Binding

Each transmitter has an individually assigned, unique ID code. Receiver should bind to
starting operation. Once binding is complete, the ID code will be stored in the receiver and no further binding
is necessary unless the receiver is used with another transmitter. When you purchase a new R9DS, this
procedure is necessary; otherwise the receiver will not work.
1. Put the transmitter and the receiver close to each other about 50 centimeters.(much too close distance
may cause signal jamming)
2. Power on AT9S Pro and receiver R9DS.
3. Turn on AT9S Pro and it will automatically bind with the closest receiver. Turn on AT9S Pro. Long press
ID SET,which is on the side of receiver for more than 1 second and release until the RED/PURPLE LED
flashes. When the LED stops flashing and is always on , binding is complete.
4. at the top of the screen means it hasn't finished binding or the failure of binding. Bind again until you
see . at the top of the screen.
Please note: Since RadioLink radio control systems are not open source, RadioLink transmitters are ONLY
compatible with RadioLink receivers. When the transmitter connect with TBS Crossfire TX, it supports
crossfire receiver.

1.3.5 Installment of antenna

Installment of antenna
Receiver Antenna Installment
① Keep antennas as straight as possible, or the effective control range will reduce.
② Big models may contain metal parts that influence signal emission. In this case, antennas should be
positioned at both sides of the model to ensure the best signal status in all circumstances.
③ Antennas should be kept away from metal conductor and carbon fiber at least half inch away and no
over bending.
④ Keep antennas away from motor, ESC or other possible interference sources.
⑤ Press and hold the ID SET for more than one second and receivers will start to work with the RED
LED on.
Note Receiver contains some electronic components of high-precision. Be careful to avoid strong vibration
and high temperature.
When all the above steps are complete, please turn off the transmitter and repower on to test if the receiver is
correctly connected with it.
1. Transmitter Antenna Installment
① The transmitter antenna is adjustable so please make sure that the antenna never points directly
at the model when flying as this may possibly decrease the receiver signal.
② Keep the antenna perpendicular to the transmitter to optimize the receiver performance. It also
depends on how you hold the transmitter. But in most cases, adjusting the antenna with perpendicular
position to the transmitter surface will achieve the best result. Please adjust the transmitter antenna
according to the way you hold the transmitter.
Never grip the antenna when flying as this degrades= effective control range.
③
16
transmitter before