Attitude; Servo-Dly; Glid Advance Menu - RadioLink AT9S Pro Instruction Manual

3.1.15 ATTITUDE

Attitude is set to switch different flight modes.There are 28
models in total. The function needs to work with flight controller.
After the transmitter connects with flight controller, name the
model in the transmitter to match with the flight mode in the
flight controller.
Channel: The attitude channel of ACRO defaults to channel 5.
It can be set from channel 5-channel 10.
There are 6 different attitude modes for MULTIROTOR:
NORMAL, ATTI, GPS, HOVER, F/S and AUX. Every mode will
have a different rate to get a unique signal. NORMAL mode
preset 0%, ATTI 50%, GPS 100%, HOVER 25%, F/S 75% and
AUX 50%.
0% means a output signal 1ms, and 100% means 2ms. You
can totally get 6 different modes by adjusting the related rates.
Goals
In ADVANCE menu find the
ATTITUDE function.
Set the
Assign the switch to control
ATTITUDE of
attitude. Ex: SW3 is SWC，SW2 is
MULTIROTO
SWB
R.
Set the rate in each attitude.
Ex: ATTI is 60%.
Close

3.1.16 SERVO-DLY

The SERVO-DELAY function is used to slow the response of the servo to stimulate the slow response of a
turbine engine. This function may also be used to create a "slowed servo" on every channel.
Adjustment range: 0%~100%
Goals
Slow down the
response of rudder
and elevon

3.2 GLID ADVANCE MENU

Steps
Steps
Open SERVO-DLY
Adjust the RATE to match the
desired servo speed.(Ex:40%)
Close
Inputs
urn on the transmitter,
menu (If ADVANCE,
to ATTITUDE
to SW3,
，
to SW2,
，
to rate-ATTI,
Inputs
to BASIC .
to SERVO-DLY,
to RATE.PUSH
56
for 1 sec. to BASIC
again)
to SWC，
to SWB，
to 60%，
，
again to ADVANCE
to 40%