Throttle Needle; Condition - RadioLink AT9S Pro Instruction Manual

Adaptable to helicopter/fixed-wing/glider/multirotor/car/boat/robot
Hide thumbs Also See for AT9S Pro:
Table of Contents

Advertisement

• Initial: 100%
• adjusting range: 0-200%
Goals
To prevent damaging the swash
linkage by simultaneous operation
of the ailerons and elevators, set
the limit point where swash throw
stops.
*Adjust the rate at the maximum
swash tilt by simultaneous
operation of the ailerons and
elevators.

3.3.13 THROTTLE NEEDLE

The setting of THROTTLE NEEDLE of helicopter is the same with that of acrobasic. Click here or go to page
54 to check the detailed setting method.

3.3.14 CONDITION

Revo., curves for idle-ups are often v-shaped to provide
proper rudder input with negative pitch and increased throttle
during inverted flight. (Rudder is needed to counter the reaction
whenever there is increased torque. In inverted flight, throttle
stick below half has increased throttle and negative pitch,
therefore increasing torque and rotating the helicopter unless the
revo. mix is also increasing appropriately.)
Additional
flight
conditions
helicopters. These additional flight conditions contain different
throttle curves, collective pitch curves, revo. mixing, and trims (except IDLE-3) to make the helicopter
perform certain maneuvers more easily. Lastly, the gyro and dual rate functions may be set to provide
separate rates per condition selected, including one for each idle-up.
Additional idle-ups may be used to maximize the helicopter's flight characteristics in certain types of flight
Steps
Open SWASH-RING
function.
Activate the function.
Adjust the rate Ex: 90%
Close
are
available
specifically
76
深圳市乐迪电子有限公司
Inputs
to BASIC menu,
ADVANCE
to SWASH-RING
to MIX
to ACT
to RATE
for
www.radiolink.com
again to
to 90%,

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents