Elevon; Start Delay (Glid 1A+1F Only); Aile-Diff（2A+1F、2A+2F; Aile-Flap(Glid 2A+2F Only)（2A+2F - RadioLink AT9S Pro Instruction Manual

"sudden stops", consider raising the ailerons and dropping the flaps in stead as shown in the diagram above.

3.2.15 ELEVON

The setting of ELEVON of glider is the same with that of acrobasic. Click here or go to page 51 to check the
detailed setting method.

3.2.16 START DELAY (GLID 1A+1F only)

START DELAY automatically switch the offset trims (OFFSET) from the
START condition's trims to the normal condition's trims after proceeding
the delay time (max.10sec.) which is set by the -DLY- item when
activating the START condition. (It is convenient for hand launch glider.)
Note: The same delay amount for elevator and rudder is
recommended when using V-tail function.
Adjustability:
• Delay time (-DLY-) range of 0 to 100%. The delay time is 10 second at
100%.
Goals Steps
Open ADVANCE menu,
then open START DELAY.
Activate the function
Ex: delay time=5
second.
Set the delay time.
(Ex:50% each surface)
Close
3.2.17 AILE-DIFF（2A+1F、2A+2F）
The setting of AILE-DIFF of glider is the same with that of acrobasic. Click here or go to page 45 to check the
detailed setting method.
3.2.18 AILE-FLAP(GLID 2A+2F only)（2A+2F）
This pre-programmed mix is used to create full span aileron action on a glider
with 4wing servos. This increases the roll rate and decreases induced drag. For normal flying, a value of
about 50% is often used. For slope racing or F3B models in speed runs, you may wish to use a larger value
approaching 100%.
Inputs
to BASIC . again to ADVANCE
to START-DLY,
to MIX to OFF or ON
，
to ELEV to 50%
，
to RUDD to 50%
，
Repeat as needed.
64
深圳市乐迪电子有限公司
www.radiolink.com