RadioLink AT9S Pro Instruction Manual page 42

Other samples:
• RUD-ELEV (ACRO GLID) mix: Compensate for pitching up or down when rudder is applied.
• AIL-RUD mix (ACRO): Coordinate turns by applying rudder automatically with aileron input. All model types.
• ELEV-PIT (HELI) mix: Compensate for the loss of lift of tilting the model
Curve Programmable Mixes (PROG.MIX5-8)(HELI: PROG.MIX5-6 ):
AT9S Pro's ACRO/GLID programs contain four separate curve programmable mixes. HELI contains two.
There are a variety of reasons you might want curve mixes. Usually a linear mix doesn't fit your needs along
the whole range. One pre-programmed curve mix is the THROTTLE-NEEDLE function. This curve is
adjustable at 5 points, allowing you to adjust the motor's tuning at 5 points along its RPM range.
One programmable curve mix defaults to RUDDER-AILERON. A linear mix that keeps the model from rolling
in knife-edge is probably too much aileron when rudder is applied in level flight. Create a curve mix and set all
5 points to match the linear mix. Inhibit the linear mix, and then adjust the curve to get the right response all
along the rudder channel's travel.
Adjustability:
• ACRO/GLID Defaults: The 4 programmable curves mixes default to the most frequent choices, but can be
set to any channel.
• PROG.MIX5 rudder-to-aileron for roll coupling compensation (GLID mixes default to aileron-to-ELEV.)
• PROG.MIX6 rudder-to-aileron for roll coupling compensation (GLID mixes default to aileron-to-ELEV.)
• PROG.MIX7 rudder-to-elevator
elevator-to-airbrake.)
• PROG.MIX8 rudder-to-elevator
elevator-to-airbrake.)
Optional: set switch to STK-THR to
activate mix with THROTTLE
STICK.
Optional: set switch position to
NULL. Make mix active at all time.
Not complete with STK-THR.
Set rate. (Ex: Lo=0%,Hi=5%)
Set OFF SET, if needed.（Ex：0）
Close
for pitch
for pitch
to SW ,PUSH
to POSI，
point .
to POSI, PUSH,
to RATE ,PUSH
0%， VR(A)past center .
to OFST
coupling compensation
coupling compensation
42
to STK-THR
Throttle Stick to desired
Push 1sec.to set.
to NULL
VR(A)，
to 0%
(GLID mixes
(GLID mixes
leave at
to 5%
default to
default to