Idle Down (Acro Only) - RadioLink AT9S Pro Instruction Manual

2.9 IDLE DOWN (ACRO only)

Lowers the engine idle for: set for sitting on the runway prior to take off,
stalls and spins, and landings. The normal idle setting is a little higher for
easier starts and safe flights with less risk of dead sticks.
Important note: The IDLE-DOWN function is not normally used when
Goals
Decrease the throttle
setting to idle with the
flip of a switch for spins
and landings.
starting the engine, and its accidental operation may keep your engine from starting. The AT9 warns that
IDLE-DOWN is on when the transmitter is turned on. Be sure to turn off the function, or override the warning
by pressing CURSOR lever if you intended the function to be on.
This may be assigned to any switch/position. Some modelers accidentally assign IDLE-DOWN to one side of
a switch and THR-CUT to the other. There is no "normal" setting to start the engine. By default IDLE-DOWN is
get to SWITCH C center and down. This works well with THR-CUT also on SWITCH C down. The SWITCH C
up is normal flight/starting, center for slower maneuvers/landing, and down to cut the engine. If you assign
IDLE-DOWN or THR-CUT to the spring-loaded TRAINER SWITCH H or F, then use the trainer function, you
Goals
Decrease the throttle
setting to idle with the
flip of a switch for spins
and landings.
may risk loss of throttle control or dead stick for your student.
Steps
Open BASIC menu,open
IDLE DOWN
Activate the function
Steps
Open BASIC menu,open
IDLE DOWN
Activate the function
Adjust the rate until engine
idles as desired with Throttle
stick.
Optional:change switch
assignment .
Close
Inputs
for 1s .(If ADVANCE
to IDLE DOWN,PUSH.
to MIX,PUSH ,
Inputs
for 1s .(If ADVANCE
to IDLE DOWN,PUSH.
to MIX,PUSH ,
Throttle Stick down,
to desired rate, PUSH
to SW, to desired position, PUSH.
29
【IDLE DOWN】
MIX：INH
RATE： 0%
SW：SwC
POST：Ct&Dn
again) .
to OFF
again) .
to OFF
to RATE,PUSH,