signal and original CH2 to CH6 output CH6 to CH10 PWM signal at the same time.
1.3.3 The connection of the receiver
Dupont thread is used to connect the receiver. The common color is white/red/black or yellow/red/brown.
The signal wire is light color, while the ground wire is dark color. The three wires are corresponding
to
. When connecting with the servo wires, the signal wire is upward and the ground wire is
downward.
Note: All RadioLink receivers are designed with Anti-polarity connect protection. When the connection of
the servo wires are reversed, the receiver will stop working and it won't be damaged. But when connecting
the servo at this time, the servo may be damaged.
The below chart is to introduce the default output channel of the receiver when setting different models.
Take acrobatic as an example.
RX
GLID(1A+1 F)
output
& CH
ELEV
FLAPERO
ON
Combi
ned
elev-2
Combined
&ailero
1
n1
&aileron-1
elev-1
&ailero
n-2
Combi
ned
Elevator/co
2
elev-1
mbined
&ailero
rudder-2&e
n-2
Glider
GLID
(2A+1F)
AILE-DIFF
N
flap-2
aileron-1
Elevator/c
ombined
rudder-2&
lev-1¹
elev-1¹
GLID
ACROBASI
(2A+2F)
C
AILE-DIF
F
ailerons/aile
Aileron-1
ron-1¹/com
bined
flap-2&ailer
on-1¹
Elevator/
combined
rudder-2
&elev-1¹
levator
13
Helicopter
Car/Boat
aileron/cycli
Spare/rudde
c roll
Spare/throttl
e
e
Elevator/cycl
ic pitch
r