Motor Cut (Throttle Cut) - RadioLink AT9S Pro Instruction Manual

2.8 MOTOR CUT (Throttle Cut)

ACROBASIC
MOTOR CUT/Throttle cut (THR-CUT) (ACRO/HELI): provides an easy way
to stop the engine by flipping a switch (with THROTTLE STICK at idle). The
movement is largest at idle and disappears at high throttle to avoid
accidental dead sticks. In HELI, there is an additional setting.
The switch's location and direction must be chosen. It defaults to NULL to
avoid accidentally assigning it to a switch, which might result in an
unintentional dead stick in flight.
Goals
Decrease the throttle
setting (at idle) to stop
the engine with the flip of
a switch.(NOTE that you
MUST assign a switch.
The default is NULL. We
recommend SWICH C in
the down position, with
IDLE-DOWN
programmed to SWITCH
C in the center and down
Optional: except using a switch,
you can set high rates to be
triggered when the stick moves
past a certain point. To test this,
set aileron high rate to 25%.Now
set switch assignment to AIL
(90%). Move AILERON STICK to
the right and notice the huge
jump in travel after the stick
moves 90% of its distance.
Set each rate's EXP.
(Ex：0%，+15%，-40%）
Repeat above steps for elevator and rudder.
Close
Steps
Open BASIC menu, then Open
THR CUT
Activate the function .Choose
desired switch, and the position
which activates the function.
With Throttle Stick at idle, adjust
the rate.
Until the engine consistently
shuts off but throttle linkage is not
binding.
to SWA
to D/R
AILERON STICK
AILERON STICK
AILERON STICK and watch screen
graph. See the change? You may also
change the trigger point by holding the
stick at the desired point then pressing
and holding the PUSH.
to EXP .PUSH
C to UP position confirm EXP reads 0.
C to DOWN position.
AILERON STICK
AILERON STICK
C to center position
Repeat to set low rate EXP to -40%.
Inputs
for 1s .(If ADVANCE
to THR CUT. PUSH. 。
to MIX,PUSH,
to SW,PUSH,
to POSI,PUSH
SWC to DOWN position.
Throttle Stick.
to Rate.
27
to AILE(90%) , PUSH
to 25%
to 25%
to+15% .PUSH
to+15%.PUSH
【MOTOR CUT】
MIX：INH
RATE： 0%
THR:5%(100%)
SW：SwH
POST：DOWN
again) .
to ON，PUSH
SWC，PUSH
to DOWN,PUSH
until shuts off.