Aile Diff (Acro/ Glid 2A+1F/ Glid 2A+2F) - RadioLink AT9S Pro Instruction Manual

FLAP-TRIM assigns the primary FLAPERON control [defaults to VR(A)] to allow trimming in flight of the flap
action of FLAPERON.
Note: Even if FLAP-TRIM is made active with AIL-DIFF, it will not have any effect. The ONLY function that
allows control of the ailerons as flaps in the AIL-DIFF configuration is AIRBRAKE. Most modelers use
AIRBRAKE, or programmable mixes, to move the flaps to a specified position via movement of a switch.
FLAP-TRIM may also be used as the primary flap control in flight. By doing so, you can assign CH6 to a
3-position switch, with a "SPOILERON", neutral, and "FLAPERON" position, and even adjust the percentage
traveled as FLAPERON/SPOILERON by changing the Flap Trim travel.
Goals
Add FLAP-TRIM to allow
the model's ailerons to
be trimmed together as
flaps at any time during
the flight, with a
maximum travel of 5% of
the total flap travel set in
FLAPERON.

3.1.4 AILE DIFF (ACRO/ GLID 2A+1F/ GLID 2A+2F)

Aileron differential is primarily used on 3 or 4-servo wings, with one servo operating inboard flap on CH6 or
CH5 & CH6, and AILE-DIFF controlling proper aileron operation of 2 aileron servos, plugged into CH1 and
CH7. The ailerons can not be moved like flaps when using AILE-DIFF, except if using AIRBRAKE. (Note that
even if you make FLAP-TRIM active while using AILE-DIFF, it will not have any effect. ONLY AIRBRAKE
controls the ailerons as flaps in the AILE-DIFF configuration.)
Note: When changing the polarity of a rate in camber-flap, "change rate dir?" is displayed for a check.
Please set up after pressing DIAL for 1 second and canceling an alarm display. (GLID only)
•
FLAP function allows you to set up 1 or 2 servos for flap action.
• The separate AILE-DIFF settings for each condition can be set. (GLID only)
Goals
Activate twin aileron servos Open the FLAPERON.
Steps
Open FLAP-TRIM function
The function is automatically activate with FLAPERON; however the default
travel is 0.
Adjust the travel available to
the FLAPERON when
turning the CH6 dial.
Close
ACRO
Steps
Inputs
to BASIC
to FLAP-TRIM.PUSH.
to 5%
GLID (2A+1F)/GLID (2A+2F)
Inputs
to BASIC menu,
45
again to ADVANCE
again to ADVANCE