High/Low Pitch (Hi/Lo-Pit) - RadioLink AT9S Pro Instruction Manual

memorized setting.
• Adjustments may be memorized and then the knobs returned to center point to use that amount of
adjustment, allows easy use of the trimming knobs for multiple models. (Note that when memorization is
repeated with the knob offset from center, the trim value accumulates.)
• Adjustments are quickly reset to the initial value by turning the dial until the trim reads 0%, memorizing, then
returning the knob to its center position.
• Note that all functions, including these, assume the model hovers at half stick.
•Available in normal (NORM) or normal/ idle-up1 (NORM/IDL1) condition only.
Goals
Fine-tune hovering with the hovering
adjustments. Remember these
affect only the hovering (normal)
condition.
Adjust throttle and collective pitch
curves until model hovers nicely. In
flight,adjust collective pitch and
throttle
curves near hover point independently
with HOV-THR and HOV-PIT knobs.
Store new settings after flight.

3.3.7 HIGH/LOW PITCH (HI/LO-PIT)

This function may be used to adjust the curves high and low side
individually for each flight condition (normal, idle-up 1, idle-up 2, idle-up 3,
throttle hold).
Adjustability:
• You may define high and low side rate trim knobs (the high side pitch trim
control is defined as the right side lever at initial setting).
• The conditions are activated in the CONDITION SELECT function.
• Both adjustments may be set to MANUAL, temporarily turning off the
knob.
• Adjustments may be memorized and then return the knobs to center point to use that amount of adjustment,
allows easy use of the trimming knobs for multiple models.
Goals
Set up a high pitch
curve in the idle-up
1condition.
Steps
Open the HOV-THR function
Optional: change which
knob adjust seach hovering
curve. NULL locks in curve
in last stored position.
Close
Open the HOV-PIT function.
Close
Steps
Open the HI/LO-PIT
Inputs
to BASIC.
ADVANCE ,
to VR
and direction
to HOV-PIT.
Inputs
to BASIC menu,
to HI/LO-PIT.
71
深圳市乐迪电子有限公司
www.radiolink.com
again to
to HOV-THR.
to desired knob
，
Repeat.
again to ADVANCE menu.