Offset - RadioLink AT9S Pro Instruction Manual

Select the idle-up 1 condition
Set the rate (Ex:80%)
Optional：Change which knob
adjusts high pitch curve.
Close

3.3.8 OFFSET

Optional separate trims in addition to those for the normal condition. This
function is used to automatically change the trim of a helicopter, for
example, when transitioned from hover to flying at high speed. A
clockwise-rotation rotor helicopter tends to drift to the right at high speed,
so an aileron offset may be applied to offset the helicopter to the left.
The necessary elevator offset varies with model geometry, so it must be
determined by noting collective pitch changes at high speed. The rudder
offset is affected by both revo. mixing and trim lever movement while in the
offset function.
Adjustability:
• Complete switch assign ability, plus a CONDITION option that creates/ switches between individual trims for
each of the idle-ups.
• When OFFSET is active (its switch is on), moving the TRIM LEVERS adjust the stored offset, not the trims in
the normal condition.
•When OFFSET is inactive (its switch is off), the OFFSET and any trim adjustments to it have no effect (model
obeys the trim settings of the currently-active flight condition.)
• When OFFSET is inhibited, trim adjustments made in any flight condition affect all flight conditions.
• Rapid jumps caused by large offsets can be slowed using the DELAY function.
• During OFFSET operation, the aileron, elevator, and rudder travels are displayed on each trim display in the
Startup screen.
Note: Remember, offsets and revo mixes are not recommended when using heading-hold/AVCS gyros
because they conflict with the automatic corrections to trim and torque that AVCS provides.
Goals
Open the OFFSET function.
Set up separate
trims for each of
the three idle-up
Change switch setting to
conditions.
Cond .
Steps
Activate the function.
to COND
，
to HI-PIT
，
to VR to desired knob and direction.
，
Inputs
to BASIC menu,
menu
to OFFSET.
to MIX to ON.
，
to SW to Cond，
，
72
深圳市乐迪电子有限公司
www.radiolink.com
to IDL1
to 80%
again to ADVANCE