RadioLink AT9S Pro Instruction Manual page 47

response, allowing the flaps/ailerons/elevator to all reach their desired end point together. A setting of 100%
slows the servo to take approximately one second to travel the prescribed distance. (GLID: B.FLY-ELEV
function)
• Adjustable in flight (ACRO): Using the aileron (when AILE-DIFF or FLAPERON is activated) and elevator
trim lever in flight can be set to adjust the aileron and elevator settings in your airbrake rather than adjusting
the model's actual aileron and elevator trim. This allows easy adjustment for any ballooning while in flight.
When the airbrake switch is moved to off the trim is again adjusting the normal elevator trim.
• Channels controlled: Elevator, twin ailerons and flap may be set independently in AIRBRAKE, including set
to 0 to have no effect.
• If FLAPERON is active, the travel of the ailerons can be independently adjusted for the servos plugged into
CH1 and CH6. The flap choice has no effect on the FLAPERON.
• If AIL-DIFF is active, then CH1 and CH7 may be independently adjusted.
• Normally both ailerons are raised equally in AIRBRAKE, and the elevator motion is set to maintain trim when
the ailerons rise. Different amounts may be set for each aileron to correct for torque reactions and other
unique characteristics of the model.
Be sure you understand what dropping ailerons will do when in AIRBRAKE BUTTERFLY. Along with
creating an enormous amount of drag (desirable for spot landings), this also creates "wash-in", a higher angle
of attack where the ailerons are, and encourages tip stalling.
If you are using this for aerobatic performance and not "sudden stops", consider raising the ailerons and
dropping the flaps instead as shown in the diagram above.
Goals
Activate AIR-BREAK
on a FLAPERON.
Mode. Adjust the
FLAPERON travel to
75%, with negative
elevator(push) of 25%.
Steps
Confirm FLAPERON is
active.
Open AIR-BREAK.
Activate the function
Adjust the travels as
needed. (Ex: Ailerons
each 75%,
Elevator-25%)
Optional: delay the
speed of the elevator
servo.
Optional: change the
mixing from full amount
upon switch to
proportional to the
Throttle Stick's proximity
to idle.
Close
Inputs
See FLAPERON instructions.
to BASIC . again to ADVANCE
AIR-BREAK. PUSH.
SW C in up position
to MIX. PUSH
to AIL1.PUSH.
to ELEV.PUSH.
to AIL2.PUSH.
to delay-ELEV. PUSH.
to MODE.PUSH.
Throttle Stick to desired 0 point.
for 1sec.till beeps
(Display changes if new setting is different from prior
47
to OFF
to +75%，PUSH
to -25%，PUSH
to +75%，PUSH
to 25%，PUSH
to Linear(0%)，PUSH.
to