RadioLink AT9S Pro Instruction Manual page 41

FLAP
•Trim: Master's trim affects slave. Not displayed if master is not CH 1-4, because 5-9 have no trim. Ex: two
rudder servos. With TRIM OFF, rudder trim would bind the two servos. TRIM ON resolves this.
• On/off choices:
• SWITCH: Any of the positions of any of the 8 switches may be used to activate a mix. Up&Cntr, Cntr&Dn
options allow the mix to be ON in 2 of the 3 positions of a 3-position SWITCH.
• NULL: No SWITCH can turn this mix OFF. This mix is active at all times.
• LOGIC SW (Lsw1 to 3) may be assigned.
• STK-THR: Turn on/off by THROTTLE STICK movement. Trigger point/direction are selectable. Ex:
OFST-to-(gear doors) mix to open gear doors at idle, which is only active if throttle is below half.
MASTER SLAVE
OFST AUX2
• Rate: the percentage of the slave's range it will move upon maximum input from the master channel. Ex:
RUDDERAILERON mix, 50%. Ail range=1''. When rudder is moved full right, ailerons move 1/2''.
MASTER SLAVE
RUDD
• Offset: Offsets the slave's center is relative to the master. Ex: Smoke valve opens wider per throttle servo
position when smoke SWITCH is ON. Smoke servo's neutral is moved down from THROTTLE STICK center
to the bottom.
MASTER SLAVE
THRO
Goals
Set up a FLAP-ELEV
mix:
ON when SWITCH C is
in the down position.
No elevator movement
when flaps move
up(spoilers),5%elevator
movement when flaps
move down. Link should
be ON if mode has twin
elevator servos.
Otherwise, Link remains
OFF.
ON
OFF
ELEV
LINK TRIM
OFF ON
LINK TRIM
AILE OFF
LINK
OFF
AUX2
Steps
Open an unused programmable
mix.(Ex: use PROG.MIX3 since it
is already set up for
FLAP-ELEVATOR)
Activate the function
Choose master and slave
channels.
Optional: set Master as OFST or
VR(A-E)
Set LINK and TRIM as needed.
Assign SWITCH and position.
(Ex: change from E to C，Down)
ANY
SWITCH POSITION
STK-THR
Stick at 1/2.for 1 sec.
SWITCH POSITION
OFF
ANY
TRIM SWITCH POSITION
OFF E
Already CH6 .Already CH2
41
NULL 5
%
RATE
100%
RATE
NULL 50%
RATE
DOWN 100%
Inputs
to BASIC menu,
to PROG.MIX PUSH
to MIX，PUSH， to ON, PUSH
to Master，PUSH，
to LINK,PUSH , to DWON
to SW，PUSH, to SwC
to POSI，PUSH
0
OFFSET
0
OFFSET
0
OFFSET
100
%
again to ADVANCE
to desired choice
to DOWN