Page 1
(Single-motor & Dual-motor Climbing Vehicles / Drift Cars / Crawlers / Trailers / Bait Boats / Rescue Boats / Surveying Boats) Note: This manual only introduces the basic usage of RadioLink COOL 9030 brushed ESC. For more information such as tutorials and FAQ, please access to RadioLink website: www.radiolink.com...
ESC will continue to consume power. If the battery is connected for a long time without use, the battery will eventually be completely discharged, which will cause the malfunction of the battery or ESC. RadioLink is not responsible for any damage caused by incorrect operation! Part 1. Introduction of COOL 9030 1.1 COOL 9030 Overview Power input: The power input of the ESC is connected to the power supply.
Status light: The status light is used to indicate the current self-check and operating status of the ESC system. The color of the light is red. Details will be introduced later. 1.2 Specifications Specifications of COOL 9030 Dimensions: 46.6*35.6*21mm Weight: Compatible models All cars &...
Drive Frequency: PWM frequency 2KHz Part 2. Connection of COOL 9030 Connect the signal cable of the ESC with the receiver correctly before use. Then connect the motor output cable of the ESC with the motor accurately (You can choose the connection direction based on actual usage.).
RadioLink Electronic Ltd www.radiolink.com batteries). At the same time, in order to make sure the stability of the system, the voltage of the input power supply must be within the range of 6.0V to 16.8V (6V to 18 V under the lithium battery mode).
RadioLink Electronic Ltd www.radiolink.com a brushed DC motor must be correctly selected to avoid damage to the ESC. At the same time, the "M+” lead wire of the motor interface is connected to the positive pole of the motor (usually a yellow or red power supply line), and the "M-"...
RadioLink Electronic Ltd www.radiolink.com Before calibrating, it is best to set the TRIM of the transmitter to “0” to avoid unnecessary trouble. Part 4. Usage of Jumper Cap 1 2 3 4 Remove jumper cap Insert jumper cap 1, 2 This ESC has four sets of jumper cap switches.
Part 5. ESC status COOL 9030 ESC has two indicator lights, red and green, to display the current operating status of the ESC. The power light is used to indicate the current self-check and power supply status of the ESC system, and the color of the light is green.
COOL 9030 ESC indicates the status of the system not only by the two indicator lights, but also by the vibration and sound principle of the motor. The combination of the two ways achieves the sound and light prompt function of the ESC system.
Thanks Thank you very much for using RadioLink COOL 9030 brushed electron speed regulator. Misuse may cause personal injury and equipment damage. Please read the instructions carefully before use and strictly abide by the prescribed operating procedures. We do not assume any responsibilities arising from the use of this product, including but not limited to compensation for incidental or indirect losses.