Removing auxiliary frame
(lowering frame unit onto engine)
•
Lower the frame unit into position from front.
e
Attention:
Make sure that all components are correctly posi-
tioned. Do not damage cables, lines and Bowden
cables.
•
Install the clutch slave cylinder.
•
Tighten the bottom fastener at the front of the
rear frame.
•
Remove the fastener securing the front spring
strut at the bottom.
•
Remove fastener securing slider tube bridge.
•
Push the leading link up.
e
Attention:
If necessary, mask off the leading link to prevent it
from being scratched.
•
Insert pin, BMW No. 46 5 630, from the left to
align the front frame bores with the correspond-
ing bores in the engine, insert the bolts from the
right and tighten.
•
Secure the slider tube bridge.
.................................................... see Group 31
a
•
Secure the leading link.
•
Remove the auxiliary frame.
11.19