BMW R 1150 R Repair Manual page 243

A
Installing rear swinging arm
33 17
•
Slide swinging arm over drive shaft as far as pos-
sible until rubber gaiter connects on housing
neck.
•
Install fixed-bearing stud bolt (1) with Loctite.
e
Attention:
When tightening threaded fasteners coated with Loc-
tite 2701, always apply final torque without delay.
Allow at least 3 hours for the Loctite to cure.
•
Install floating-bearing stud bolt (2) with Loctite.
•
Tighten fixed bearing stud bolt.
•
Tighten floating bearing stud bolt.
•
Firmly tighten locknut.
•
Secure spring strut.
1
X
Tightening torque:
Fixed bearing stud
(clean thread + Loctite 2701)...................... 160 Nm
Floating bearing stud
(clean thread + Loctite 2701).......................... 7 Nm
Locknut ...................................................... 160 Nm
Spring strut to swinging arm
(clean thread + Loctite 243).......................... 58 Nm
Spring strut to rear frame ............................. 50 Nm
A
2
R28330020
33.21