BMW R 1150 R Repair Manual page 4

BMW Motorrad
Maintenance schedule
R 1150 R
Customer
Job Order No.
Use BMW MoDiTeC to read stored error codes from fault memory
[Integral ABS] Performing bleed test with BMW MoDiTeC
Change engine oil, warmed to normal operating temperature, replace oil filter
when used exclusively in short-distance operation, or at outside temperatures below 0°C (32 °F),
or no later than every 3 months, or every 3,000 km/1,800 miles
Change oil in gearbox, with oil warmed to normal operating temperature
*)
at least every 2 years
Change final-drive lubricant, warmed to normal operating temperature
every 40,000 km/25,000 miles, or no later than every 2 years
*)
Replace fuel filter
Standard replacement interval is 40,000 km/25,000 miles, with substandard fuel quality every 20,000 km/12,000 miles
Check battery electrolyte level, top up with distilled water as necessary
Battery terminals, clean and grease as necessary
Replace intake air filter element
Replace air filter every 10,000 km/6,000 miles when vehicle is exposed to high levels of dirt and dust,
*)
or more frequently as indicated
Check front/rear circuit brake fluid
Check operation of brake system, inspect for leaks; repair/replace as indicated
Check brake pads and discs for wear, replace as required
[Without Integral ABS] Change brake fluid annually
[Integral ABS] Change wheel-circuit brake fluid at least once a year
[Integral ABS] Change control circuit brake fluid at least every 2 years
[Integral ABS] Perform bleed test with BMW MoDiTeC
Check clutch operating fluid level
Change clutch hydraulic circuit fluid
at least every 2 years
Check rear lug bolts to ensure they are tight
Check rear wheel bearing play by tilting wheel
Check swing arm bearings (no play), adjust as required
Check operation of side stand switch
Grease the side stand pivot
Retention poly-V-belt
Re-adjust new poly-V-belt one time at 10,000 km/6,000 miles
*)
Replace poly-V-belt
Replace poly-V-belt every 60,000 km/35,000 miles
Inspect spark plugs
Replace spark plugs
Retorque cylinder heads
Check valve clearance and adjust as necessary
Check throttle cable for ease of motion, inspect for abrasion and bends, replace as indicated
Check cable free travel
Check synchronisation, adjust as necessary
Final inspection with operation assessment and road safety check:
– Condition of wheels and tyres, tire inflation pressure
– Clutch, shift mechanism, hand and foot brakes, steering
– Lighting and signal indicators, warning and indicator lamps, instruments
– Optional equipment
– Conduct road test as required
*) Write up on separate invoice;
Order No. 01 71 0 141 316
Licence No.
Date
*)
*)
*)
*)
*)
Not part of standard service procedure
UX-VS-2, 05.2001 1st edition
Mileage
Mechanic's signature
*)
*)
*)
BMW recommends Castrol