Ihse Draco MultiView 4K60 MV42 Series User Manual page 81

Draco MultiView 4K60
SNMP Trap
The SNMP agent must be activated to activate the SNMP traps.
Traps
Enable Traps
Server Address
Status
Power Supply #1
Power Supply #2
Switch Command
Insert Output
Remove Output
Video Change IN
EDID Change
Activating the SNMP Agent
To activate the SNMP agent, proceed as follows:
1. Select Configuration > SNMP in the main menu.
2. Set the Enable option to Y (Yes) within SNMP Agent.
By activating this option, the permission for an active query of the SNMP agent is granted.
Activate SNMP Traps
To activate SNMP traps, proceed as follows:
1. Set the Enable Traps option to Y (Yes) within SNMP Server.
This function allows an active transmission of trap messages from the SNMP agent to the SNMP server.
2. Set the IP address of the SNMP server within Server Address.
3. Set the requested traps to Y (Yes) to enable them.
Description
Sending of trap messages from the SNMP agent to the SNMP server.
IP address of the SNMP server in the form "192.168.1.1" and of the SNMP port (default:
162).
Notification about the Draco MV status.
Notification about the status of power supply unit #1.
Notification about the status of power supply unit #2.
Notification about a performed switching operation at the Draco MV.
• Notification about a newly connected console to the Draco MV.
• Notification about a switched-on console.
• Notification about a removed console from the Draco MV.
• Notification about a switched-off console.
Notification about a change of resolution or change of frequency.
Notification about a change in EDID information at the inputs.
Configuration via OSD
81