Ihse Draco MultiView 4K60 MV42 Series User Manual page 76

Configuration via OSD
The following parameters can be configured:
Network Interface
Field
DHCP
IP Address
Field
Subnet Mask
Gateway
Multicast
Network Services
Field
API Service
SSL/TLS Support
Maintenance Service
Syslog #1/#2
Syslog Server #1/#2
Log Levels
Field
Trace
76
Entry Description
Y The network settings are automatically supplied by a DHCP server.
Note: If DHCP is activated and there is no physical network connection
available, the boot times might increase.
N Function not active (default).
Byte Enter the IP address if DHCP is not active (default: 192.168.100.95).
Entry Description
Byte Enter the subnet mask in the form "255.255.255.0" if DHCP is not active
(default: 255.255.255.0).
Byte Enter the gateway address in the form "192.168.1.1" if DHCP is not
active.
Byte Enter the multicast address if using within a multicast group (default:
broadcast 255.255.255.255).
Entry Description
Y Activate the LAN interface at the Draco MV for access via Web UI (API
service port 7055/7056) (default).
N Function not active.
Activated Activates SSL/TLS encryption for API, Web UI API, Web UI and
Draco MV communication.
N Function not active (default).
Y Enable the maintenance service for advanced diagnostic.
N Function not active (default).
Y Activate the Syslog server for status requests.
N Function not active (default).
Byte Enter the IP address of the Syslog servers in the form "192.168.1.1" and
of the Syslog port (default: 514).
Entry Description
DEB Activate debug messages in trace (default: N).
Note: The debug messages are exclusively for Draco MV diagnostics.
Use this function only for concrete debug cases as it is not intended for
normal operation.
INF Activate information messages in trace (default: N).
NOT Activate notification messages in trace (default: Y).
WAR Activate warning messages in trace (default: Y).
ERR Activate error messages in trace (default: Y).
Draco MultiView 4K60