Table of Contents
Advertisement
Magstim Rapid
2
SECTION: 2. PRODUCT DESCRIPTION
2.1 RAPID
2
Unit Power Status Indicator
•
Flashes when the system
is in STANDBY.
•
On continuously when
the system is ON.
ON/OFF/STANDBY
This switch toggles the
operational state of the
Rapi,f.
ARMED Indicatm·
illuminated v,rhen the
is armed and high voltages
are present in the system.
Coil OUTPUT Socket
See below for description
PSU Power Status
•
•
On continuously when
system is ON
ARMED/FAULT Indicator
This LED is continuously illuminated when the system is anned and high voltages are present
in the system. This LED turns RED when a fault has been detected in the PSU.
Coil OUTPUT Socket Operation and SYMBOLS
3576-23-09
This socket is used to connect the stimulating coil to the Magstim Rapid
2 .
Note that the unit cannot be
anned and triggered unless the stimulating coil is connected to this output. Ensure that the locating pin in
the coil plug is correctly lined up \.vith the coil output socket before inserting the plug. When the coil plug is
fully engaged in the socket. lock the plug in place by turning the black locking ring clockwise.
To remove the coil, put the Magstim Rapid
2
into standby and tum the black locking ring anti-clockwise.
HIGH VOLTAGE Symbol
This sign warns that voltages in excess of 1 SOOV are present within the instn.unent.
ATTENTION Symbol- Consult Operating Manual
See warnings in Section 1 regarding the use of the Magstim Rapid
2 .
APPLIED PART Symbol
BF Type Applied Part.
The l\'IAGSTIM Company LTD
3
November 2009
UI
Main
Frame
PSU
Advertisement
Table of Contents
