MAGSTIM RAPID2 Operating Manual page 58

Magstim Rapid
2
3576-23-09
SECTION 11: E~1C EMISSIONS AND IM~1UNITY
Guidance and Manufacturer's Declaration - Electromagnetic Emissions
The Magstim Rapid 2 System is intended for use. in the. electromagnetic environment specified be.low. The
customer or the. use.r of the equipme.nt should assure that it is used in such an environment.
Emissions Test Compliance
Electromagnetic environment - guidance
RF emissions Group 1 TI1e Magstim Rapid 2 System must emit electromagnetic energy in
EN55011 order to perfom1 its intended fonction. Nearby electronic equipment
may be affected.
The Magstim Rapid- System is suitable for use in all establishments
RF emissions Class A other than domestic and those directly connected
to
the public lmv-
EN5501 l voltage power supply network that supplies buildings used for
domestic purposes.
Ham10nic Class A
Emissions
(by equipment
IEC 61000-3-2
type)
Voltage
fluctuations/ flicker
Complies
enuss10ns
IEC 61000-3-3
Guidance and ]\.fanufacturer's Declaration - Electromagnetic humunitv
The Magstim Rapid 2 System is intende.d for use in an electromagnetic environment in which radiated RF
disturbances are controlled. The customer or the user of the Magstim Rapi(.f System can help preYent
electromagnetic interference by maintaining a minimum distance between portable and mobile RF communications
equipment (transmitters) and the Magstim Rapid 2 System as recommended belO\v, according
to
the maximum
output power of the communications.
Rated maximum output Separation distance according to frequency of transmitter
power of transmitter m
w
150 kHz to 80 MHz 80 MHz to 800 MHz 800 MHz to 2,5 GHz
3~5
- -
3.5
- -
7
d~ [-----HP d~[---i~P
d
~
[
---i
FF-
Vi
E1
Ei
Where
Vi~
3 vv11ere E 1 ~ 3 \\'he.re E
1
~ 3
0.01
0,117 0,117 0,233
0.1
0,369
0.369 0.738
l !J67
1,167 2,333
10 3,689
3,689
7,379
100 11.667 11.667 23.333
For transmitters rated at a maximum output power not listed above, the reco11m1ended separation distanced in
me.tres (m) can be estimated using the equation applicable.
to
the. fre.quency of the. transmitter, where Pis the
maximum output power rating of the transmitter in watts (W) according to the transmitter manufacturer.
NOTEl At 80 MHz and 800 MHz, the separation distance for the higher frequency range applies.
NOTE2 These guidelines may not apply in all situations. Electromagnetic propagation is affected by absorption
and reflection from structures, objects and people.
The l\'IAGSTIM Company LTD
55
November 2009