MAGSTIM RAPID2 Operating Manual page 59

Magstim Rapid
2
3576-23-09
Guidance and Manufacturer's Declaration - Electroma~netic Immunity
The Magstim Rapict1 System is intended for use in the electromagnetic environment specified below.
The customer or the user of the equipment should assure that it is used in such an environment.
Immunity Test IEC 60601 Compliance Electromagnetic enYironment -
Test LeYel LeYel ~uidance
Electrostatic ± 6 kV contact Meets requirement Floors should be wood. concrete or ceramic
discharge (ESD)
±
8 kV air tile. If floors are covered with synthetic
material, the relative. humidity should be at
IEC 61000-4-4 least 30%.
Electrical fast ± 2 kV for power Meets requirement Mains power quality should be that of a
Transient/ burst
supply lines (Resetting of the typical commercial or hospital
MEP Pod may be environme.nt.
IEC 61000-4-11 ± l kV fr,r input/
experienced during
output lines single shot mode
under these
conditions.)
Surge ± l kV differential Differential mode Anti surge protection needs to be
mode compliant. incorporated into the main supply to the
IEC 61000-4-5 equipment if surge protection is to be
± 2 kV common Common mode guaranteed.
mode compliant to± lkV
only.
Voltage dips, <5
~:Q
l/T
Meets requirement Maim power quality should be that of a
short inte1n1ptions (>95 ?o dip in UT) for typical commercial or hospital
and voltage. 0.5 cycle environment. If the user of the Magstim
Yariations on Rapid 2 System requires continued
power supply 40 ?-o Uy operation during power interruptions, it is
input lines. (60
%
dip in UT) for recommended that the Magstim Rapid 2
5 cycles System be pmvered from an interruptible
IEC 61000-4-11
power supply.
70% Uy
(30 % dip in UT) for
25 cycles
<5% UT
(>95 % dip in UT) for
5 sec
Power Frequency 3 A/m 50Hz Meets requirement Power frequency magnetic fields should be
(50!60Hz) at levels characteristic of a typical location
Magnetic Field in a typical commercial or hospital
environme.nt
IEC 61000-4-8
Radiated RF 80MHz - 2.5GHz Coil adapter P/N Equipment should only be used in the
Immunity 2Hz 80'% amplimde 3110-00 and Cooled vicinity of other equipment compliant with
EN6 l 000-4-3 modulation Coil PIN 3380-00 EN60601-1-2.
between 80l'vIHz and
l00MHzmay
produce system
effors setting system
into safo mode.
Conducted RF 0.15MHz - 80MHz Coil adapter P/N Equipment should only be used in the
Immunity 2Hz 80%, amplitude 3110-00 and Cooled vicinity of other equipment compliant with
EN61000-4-6 modulation Coil
PIN
3380-00 EN60601-1-2.
between 30MHz and
80MHz may produce
system errors se-tting
system into safe.
mode.
NOTE UT is the a.c. mains voltage prior to application of the test leve.l
The l\'IAGSTIM
Company
LTD
56
November 2009