Isolated Trigger Port; Sd Card File Details - MAGSTIM RAPID2 Operating Manual

Magstim Rapid
2
3576-23-09
7.2 ISOLATED TRIGGER 1/0 PORT (l)
WARl~ING Only equipment complying with EN 60601-1, and configured in compliance
with EN 60601-1, should be connected to the trigger output and/or trigger
input. Connection must be via Trigger Input/ Output Cable P;N 600003 in
order to maintain System EMC Compliance
I/O - SV CMOS Logic Levels.
Pin Connections.
I.Aux GND
2.N!C
3. Tout- O/C
4. N/C
5.
+ive Trigger In
6. -ive Trigger In
7. +ive Trigger Out
8.
-ive Trigger Out
9. N/C
10.Aux +5V
11. AuxGND
12. N!C
13. NiC
7.3 SD CARD FILE DETAILS
• General
14.NiC
15. N/C
16.N/C
17. N/C
18. N/C
19.AuxGND
20. End Train
21. N/C
22.NiC
23. N!C
24. Trigger Edge
25. N/C
26. N/C
Each line of the file staiis with a text string that describes the data that follows on that line.
Each line of data ends with a can-iage return line feed request, <CR>.
• File Layout
The following details the order the data is stored in the Magstim UI generated file.
Ve1·sion, <file format munber>, <CR>
File, <system filemm1e>, <CR>
Status, <system file status when exported>, <CR>
File Time, <seconds>, <minutes>, <hours>, <day>, <month>, <year>, <CR>
Name, <patient name>, <CR>
Sex, <patient sex>, <CR,>
ID#, <patient ID>, <CR>
Date or birth, <patient date of birth>, <CR>
Protocol description, <patient protocol description text string>, <CR>
Comments, <patient comments string>, <CR>
T1·ain, <power>, <frequency>, <duration>, <number of pulses>, <wait time>, <number of trains>,
<CR>
Burst, <power>, <frequency>, <number of pulses>, <burst frequency>, <number of bursts>, <cycle
time>, <number of cycles>, <CR> *see note 1.
Session 1, <start time>, <power>, <frequency>, <duration>, <number of pulses>, <wait time>, <CR>
Session 2, <start time>, <power>, <frequency>, <duration>, <number of pulses>, <wait time>, <CR>
Session 30, <start time>, <power>, <frequency>, <duration>, <number of pulses>, <wait time>, <CR>
MEP 0, Trace I.Trace 2, <CR>
MEP 1, <reading l trace!>, <reading 1 trace2>, <CR>
MEP 2, <reading 2 trace!>, <reading
2
trace2>, <CR>
MEP 3, <reading 3 trace!>, <reading 3 trace2>, <CR>
MEP 4, <reading 4 trace!>, <reading 4 trace2>, <CR>
MEP 300, <reading 300 trace!>, <reading 300 trace2>, <CR>
!\1EP Configurntion, <time base index>, <channel l voltage range index>, <channel 2 voltage range
index>, <special feature>, <filters index>, <CR>
The MAGSTIM Company LTD
39
November 2009