Externally Managed Switches; Figure 28: Two Power Inlets - Electric Caution Notifications - Mellanox Technologies SwitchX-2 MSX6005F-1BFS Hardware User Manual

Rev 1.0
Risk of electric shock and energy
hazard. The two PS units are
independent.
Disconnect all power supplies to
ensure a powered down state
inside of the switch platform.
3.6

Externally Managed Switches

Externally managed switches, that is the SX6005 switches, do not have a management chip or
management board within the switch. These switches do not get configured. On externally man-
aged switches, the CONSOLE, Ethernet, and USB connectors are not found. Instead there is an
I2C connector.
The externally managed switches are Plug and Play and all firmware updates should be done in-
band. The I2C connection should only be used if the firmware image was corrupted to the point
that the regular firmware tools cannot successfully reburn the correct image.
40 Mellanox Technologies
This unit is intended for installation in a Restricted Access Location. A restricted
access area can be accessed only through the use of a special tool, lock and key, or
other means of security.
Caution: After inserting a power cable and confirming the green system status LED
light is on; make sure that the Fan Status indicator shows green.
If the fan status indicator is not green then unplug the power connection and call
product support.
Caution: When turning off the switch, make sure ALL Connector LEDS are off to
ensure a powered down status.

Figure 28: Two Power Inlets - Electric Caution Notifications

CAUTION
Gafahr des elektrischen
Schocks. Entferrnen des
Netzsteckers elnes Netz-
teils spannungsfrei. Um
alle Einhieten spannungs-
frei zu machen sind die
Netzstecker aller Netzteile
zu entfernen
This unit is intended for installation in a Restricted Access Location. A restricted
access area can be accessed only through the use of a special tool, lock and key, or
other means of security.
ACHTUNG
Risque de choc et de danger 
e'lectriques. Le de'branch-
ment d'une seule alimentation
stabilise'e ne de'branch
uniquement qu'un module
"Alimentation Stabilise'e".
Pour isoler completement le
module en cause, Il faut
de'brancher toutes les alimen-
tations stabilise'es.
ATTENTION
Installation