Table 6: System Status Leds - Mellanox Technologies SwitchX-2 MSX6005F-1BFS Hardware User Manual

SwitchX®-2 12 Port InfiniBand Switch System Hardware User Manual
Table 6 - System Status LEDs
Symbol
Switch
Fan Status LED
PS1
Power supply #1
PS2
Power supply #2
Bad Port LED
UID
Unit Identifier LED
The system status LEDs should display as follows:
Switch
• when the switch is plugged in, within five minutes the switch status LED should light
up green
• the FAN LED should light up green. If the FAN LED shows red, replace the switch.
• the PS1 LED for the plugged in PS unit should light up green
• the PS2 LED for the second PS unit should light up green only if a second PS unit is
installed in the switch for redundancy and it is connected to a power source
• if two PS units are installed and only one PS unit is connected to a power supply the PS2
LED will be red
• if only one PS unit is installed in the switch, the PS2 LED will be off
If the PS LEDs are not green, this indicates a problem with the power supplies. The switch is
operational only if at least one of the PS LEDs is green.
Name
Status LED Shows the health of the
Shows the health of the fans
Shows the health of the right side power supply unit
Shows the health of the left side power supply unit
lights up when a symbol error is detected
Lights up on command through the CLI
As long as there is power to the switch (one PS unit is connected), and the switch is
booted up and running, the switch status LED should be green.
If the status LED shows red after five minutes, unplug the switch and call your Mella-
nox representative for assistance.
If the switch shuts down due to over temperature, unplug the switch, wait 5 minutes
and replug in the switch. For more information See page 53.
Description
switch
Mellanox Technologies
Rev 1.0
Normal Conditions
Solid green after 5 minutes
Green
Green
switch
Depends on
Off
Off
17