Mellanox Technologies SwitchX-2 MSX6005F-1BFS Hardware User Manual page 46

Rev 1.0
RX bytes:
RX packets:
RX mcast packets: 0
RX discards:
RX errors:
RX overruns:
RX frame:
6. Run the command:
show version
7. Compare the results of this command with the latest version for your switch posted on the
support page for your
 Rerunning the Wizard
8. If you want to rerun the wizard run the following commands:
switch > enable
switch# configure terminal
switch (config) # configuration jump-start
3.7.2 Starting a Remote Connection to the Switch
There are two ways to access the management CPU:
• Via the Ethernet connector for remote access:
• SSH
• Telnet
• Web
• SNMP
• XML
 To Start an SSH Connection to the Switch perform the following steps:
1. Set up an Ethernet connection between the switch and a local network machine ("the remote
machine" henceforth) using a standard RJ-45 connector.
2. Connect to the remote machine (rem_mach1 is used as an example).
46 Mellanox Technologies
1343502058
17589211
0
0
0
0
Confirm that the latest SW revision is installed on this device. Use the CLI to get the
currently installed revision and then go to Mellanox.com to check the revision of the
latest version.
switch. This page will need a support login and password.
For additional information on the MLNX-OS refer to MLNX-OS User Manual and
MLNX-OS Command Reference Guide located on Mellanox support web.
TX bytes: 313920869
TX packets: 992717
TX discards: 0
TX errors: 0
TX overruns: 0
TX carrier: 0
TX collisions: 0
TX queue len: 1000
Installation