Mellanox Technologies SwitchX-2 MSX6005F-1BFS Hardware User Manual page 31

SwitchX®-2 12 Port InfiniBand Switch System Hardware User Manual
17. Add GND connection information
Before connecting this device to the power line, the protective earth terminal screws
of this device must be connected to the protective earth in the building installation.
(GND Connection Information):
The building installation shall provide a means for a connection to protective earth;
and the equipment shall be permanently connected to that by a service person.
A SERVICE PERSON shall check whether or not the socket - outlet from which the
equipment is to be powered provides a connection to the building protective earth. If
not, the SERVICE PERSON shall arrange for the installation of a PROTECTIVE
EARTHING CONDUCTOR from the separate protective earthing terminal to the
protective earth wire in the building. The equipment shall be installed in area where
equipotential bonding exists ((such as a telecommunication centre or a dedicated
computer room).
18. Interconnection Of Units
Cables for connecting to the unit RS232 and Ethernet Interfaces must be UL
certified type DP-1 or DP-2. (Note- when residing in non LPS circuit)
Overcurrent Protection: A readily accessible Listed branch circuit overcurrent
protective device rated 20 A must be incorporated in the building wiring.
19. Hazardous Radiation Exposure
Caution – Use of controls or adjustment or performance of procedures other
than those specified herein may result in hazardous radiation exposure.
CLASS 1 LASER PRODUCT and reference to the most recent laser stan-
dards IEC 60 825-1:1993 + A1:1997 + A2:2001 and EN 60825-
1:1994+A1:1996+ A2:2001
20. Proper Enclosure
A suitable electrical, mechanical and fire enclosure shall be provided by the end prod-
uct manufacturer and or the end user.
21. Do Not Use the Switch as a Shelf or Work Space
Caution: Slide/rail mounted equipment is not to be used as a shelf or a work space.
The rails are not intended for sliding the unit away from the rack. It is for permanent
installation at final resting place only, not used for service and maintenance
Mellanox Technologies
Rev 1.0
31