Mellanox Technologies SwitchX-2 MSX6005F-1BFS Hardware User Manual page 43

SwitchX®-2 12 Port InfiniBand Switch System Hardware User Manual
Table 14 - Configuration Wizard Session - DHCP (Sheet 2 of 2)Configuration (Example)
Wizard Session Display
Step 2: Use DHCP on mgmt0
interface? [no] yes
Step 3: Enable IPv6? [yes]
Step 4: Enable IPv6 auto-config
(SLAAC) on mgmt0 interface?
[no]
Step 5: Enable DHCPv6 on
mgmt0 interface? [no]
Step 6: Admin password (Press
<Enter> to leave unchanged)?
<new_password>
Step 6: Confirm admin pass-
word? <new_password>
You have entered the following
information:
<A summary of the configura-
tion is now displayed.>
To change an answer, enter the
step number to return to or hit
<enter> to save changes and exit.
Choice: <Enter>
Configuration changes saved.
The table below shows an example of static IP configuration for mgmt0 interface.
Comments
Perform this step to obtain an IP address for the switch.
(mgmt0 is the management port of the switch.)
If you wish the DHCP server to assign the IP address,
type 'yes' and press <Enter>.
If you type 'no' (no DHCP), then you will be asked
whether you wish to use the 'zeroconf' configuration or
not.
If you enter 'no' (no Zeroconf), then you need to enter a
static IP, and the session will continue.
The management interface will be able to use IPv6
addresses.
This turns on auto-configuration of the IPv6 addresses.
This is unsuitable for DHCPv6.
To enable DHCPv6 on the MGMT0 interface.
To avoid illegal access to the machine, please type a pass-
word and then press <Enter>. Then confirm the password
by re-entering it.
Note that password characters are not printed.
The wizard displays a summary of your choices and then
asks you to confirm the choices or to re-edit them.
Either press <Enter> to save changes and exit, or enter the
configuration step number that you wish to return to.
Note:
To re-run the configuration wizard run the command
"configuration jump-start" in Config mode.
Mellanox Technologies
Rev 1.0
43