Replacing The Drive Belts - DENTSPLY ORTHORALIX 9200 Manual

ORTHORALIX 9200
Service Manual

5.5. REPLACING THE DRIVE BELTS

The belts for all the movements (X, Y, R and Cassette) are the
same, only the length is different; as spare part, a belt 1 meter long
is supplied: it is a task of the service engineer to cut the belt at the
right length, comparing the new one with the old one.
For the replacement of the X drive belt proceed as follows:
(1) Loose the belt stretcher by unscrewing the nut (a) and
then screw (b).
(2) Remove the screws (c) with plates and replace the belt
(d).
(3) Ensure that the plates are properly accommodated on
the teeth of the new belt, then fix them with securing
screws (c).
(4) For the adjustment of the belt tension refer to paragraph
TENSION ADJUSTMENT OF THE DRIVE BELTS of this
Section F.
DENTSPLY Gendex
(03.0)E
Section F
F-35